Article

Related resources

Related resources

Related resources

Fire retardant gel ― can it really help?

The research on fire retardant gels for wildfire protection

In a study conducted in collaboration with the University of North Carolina at Charlotte, the Insurance Institute for Business and Home Safety (IBHS) evaluated the long-term effectiveness of fire-retardant gels when applied to a wood-based substrate. These gels are a type of coating meant to provide protection over a period of a few hours and are typically applied manually just prior to the arrival of a wildfire. The gels act as a protective heat sink on the material they are applied to, reducing the effects of thermal exposure and therefore potential to ignite.

 The operating principle of these fire-retardant gels is based on hydration and their effectiveness is reduced as the gels lose moisture. Wind speed and relative humidity affect the dehydration rate. High wind speed and low relative humidity are common conditions when wildland fires threaten homes. These conditions caused gels to dehydrate more than 10 times faster than moderate conditions (low wind speed and high relative humidity).

Two products were tested in this study: Gel Type A used a vegetable cooking oil-based mixing agent; Gel Type B used a petroleum-based mixing agent.

 

Key findings:

  • Fully hydrated, both gels tested can increase the time-to-ignition from 15 seconds to over 7 minutes.
  • At 50 percent dehydration from initial mass, the time-to-ignition was reduced by nearly half: from over 7 minutes to 4 minutes for Gel A, and less than 3 minutes for Gel B.
  • In a realistic wildland fire scenario of 10 percent relative humidity and a wind speed of 10 m/s (22 mph) both gels reach 50 percent dehydration in less than 1.5 hours and full dehydration1 in 7 hours.
  • A completely dehydrated petroleum-based mixing agent gel may create a hazardous condition more susceptible to ignition than untreated T1-11 plywood.
  • During application, the gel can clog the spray nozzle which may be difficult to clean and adds additional time to the process.
  • Removal and cleanup of fire-retardant gels after a fire has been reported to pose some challenges for homeowners. However, once dehydrated the products tested could be peeled off easily.

IBHS conclusions:

  • Time is against you ― Fire retardant gels dehydrate, sometimes quickly. They can lose their effectiveness after only a few hours.
  • Gels can become a fire hazard ― When completely dehydrated, some gels may create a hazardous condition more susceptible to burning than untreated plywood.
  • Application issues ― Applying gels can be cumbersome. It can consume precious time you and your family need to evacuate safely.
  • Leave it to professionals ― Gels can be effective if applied by firefighters a short period of time before the fire reaches your home.

 

Source: IBHS 

Insurance institute for business and home safety

 

 

 

 

 

The recommendation(s), advice and contents of this material are provided for informational purposes only and do not purport to address every possible legal obligation, hazard, code violation, loss potential or exception to good practice. The Hanover Insurance Company and its affiliates and subsidiaries ("The Hanover") specifically disclaim any warranty or representation that acceptance of any recommendations or advice contained herein will make any premises, property or operation safe or in compliance with any law or regulation. Under no circumstances should this material or your acceptance of any recommendations or advice contained herein be construed as establishing the existence or availability of any insurance coverage with The Hanover. By providing this information to you, The Hanover does not assume (and specifically disclaims) any duty, undertaking or responsibility to you. The decision to accept or implement any recommendation(s) or advice contained in this material must be made by you.

LC 2021-361